مقاله Chemical energy and bottom stirring systems – Cost effective solutions for a better performing EAF

توجه : به همراه فایل word این محصول فایل پاورپوینت (PowerPoint) و اسلاید های آن به صورت هدیه ارائه خواهد شد

 مقاله Chemical energy and bottom stirring systems – Cost effective solutions for a better performing EAF دارای ۱۳ صفحه می باشد و دارای تنظیمات در microsoft word می باشد و آماده پرینت یا چاپ است

فایل ورد مقاله Chemical energy and bottom stirring systems – Cost effective solutions for a better performing EAF  کاملا فرمت بندی و تنظیم شده در استاندارد دانشگاه  و مراکز دولتی می باشد.

توجه : در صورت  مشاهده  بهم ریختگی احتمالی در متون زیر ،دلیل ان کپی کردن این مطالب از داخل فایل ورد می باشد و در فایل اصلی مقاله Chemical energy and bottom stirring systems – Cost effective solutions for a better performing EAF،به هیچ وجه بهم ریختگی وجود ندارد

بخشی از متن مقاله Chemical energy and bottom stirring systems – Cost effective solutions for a better performing EAF :

سال انتشار : ۲۰۰۹

تعداد صفحات :۱۳

The continuous improvement of EAF performance is crucial for the increase in productivity and cost effectiveness and to render an environmental friendly process. RHI supports these targets by providing a diverse range of refractory and process solutions. Chemical energy in practical operation by injection of gaseous media like oxygen and natural gas, and solid materials like carbon have become a state of the art solutions for process improvement today. To understand the phenomena of the benefits, RHI has developed a mass and energy balance model. The objective of the model is to focus on the replacement ratio of electrical energy by chemical energy and the consequences for the overall CO2 emission of the process. CO2 emission certificate trading can become a new source for cash generation to be utilized for improvement investment budgets.

Another valuable solution to decrease the energy consumption and the CO2 generation of the process is bottom purging in EAF. This technology can be introduced by the use of the directional porosity plug (DPP). The benefit of stirring in the furnace is that it enhances the interface reactions between the slag and the bath and homogenizes the liquid volume in the furnace. This results in achieving better operation parameters in terms of less power consumption and power-on time. Again a benefit in cost and a reduction in carbon dioxide emissions can obviously be attained. This paper shows the savings potential of the replacement of electrical energy by chemical energy by using the mentioned balance model. The benefit of the introduction of the DPP system is shown on the results of various steel plants.